Caution, Wiring monitor, Vom-783 operations manual – ASA Electronics VOM-783 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
VOM-783 OPERATIONS MANUAL
** CAUTION **
1. Before drilling, be sure no cable or wiring is on the other side. Be sure to drill a 19mm (3/4") diameter hole only.
2. Feed as much cable as possible into vehicle and clamp securely. This reduces the possibility of being hooked
during production.
3. Keep all cables away from HOT, ROTATING and ELECTRICALLY NOISY components.
4. To increase protection of cable, place all excess wire and extension cable in convoluted tubing.
5. Do not twist camera cable and do not cut camera pigtail or cable.
WIRING MONITOR
1. See wiring diagram for connections.(See Fig.3)
2. Wiring Monitor:
Insert extension cable into camera #1 position if three cameras are used , be sure to mark each extension cable
properly, plug second and third cables into camera #2 or #3 position.
Bundle excess cable together using a cable tie or vinyl tape. This will avoid possible damage to cable during
operation.(See Fig.3)
3. The red wire is connected to an ignition power source, the black wire
is connected to chassis ground, and the blue wire is connected to the rear gear position, the brown and green wires
are connected to the direction signals.(See Fig.3)
4
Voyager