Assembling the sound absorbing panel, Leveling, Connecting the drain hose – Avanti W751SC User Manual
Page 9: In case of pump-drained washer
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION INSTRUCTIONS
> Assembling The Sound Absorbing Panel
Lay down the washer with the rear side facing up and insert the panel until it clicks into the five slots provided (as
shown in the figure). Use the screw in the hole provided to tighten the absorbing panel to the bottom of the washer.
Screw
> Leveling
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE WASHING TUB.
*
Open the lid of the machine, pour water into the tub up to the level just below the pulsator, and adjust the
legs so that the pulsator is positioned at the center of the water as shown in the figure.
•
Place the machine more than 10cm away from the wall.
Adjust the front legs on feet for levelling.
Loosen .M, Lock
Note: The protective rubber support inserts may leave marks on certain floor types,
|
To prevent possible markings place a small piece of cloth, or similar item,
-|]J
under the rear legs when the machine Is in use.
\b\
O' Support Leg
> Connecting The Drain Hose
• After pressing the joint ring (a). Insert the drain hose (b) to drain direction.
> In Case of Pump-Drained Washer
•Take out the cap-hose and connect the outlet hose.
•Be sure to join tightly the drain hose outlet on the back of the machine.
•Install the drain hose 28-32 inches above the ground.
cap-hose
ZZM
outtet-hose
CAUTION : Drain hose may pop up during draining due to heavy water pressure. This is normal.
We suggest to hold it down with a heavy water proof object, to keep hose in place.
d)