CLIFFORD 562C - Manual (Page 21)

This feature allows your system's remote start unit to be tem-
porarily disabled to prevent the vehicle from being remote start-
ed accidentally. This feature is useful if the vehicle is being ser-
viced or stored in an enclosed area. To disable the remote start,
move the shutdown toggle switch to the OFF position. The switch
can be installed in a location of your choice. Check with your
installer for recommended locations.
LOCATION OF SHUTDOWN SWITCH_________________________
Rapid Resume Logic
This Directed Electronics system will store its current state to non-
volatile memory. If power is lost and then reconnected the system
will recall the stored state from memory. This means if the unit is
in Valet ® Mode and the battery is disconnected for any reason,
such as servicing the car, when the battery is reconnected the unit
will still be in Valet Mode. This applies to all states of the system
including arm, disarm, VRS ® , and Valet Mode.
Disabling the Remote Start System
17
© 2004 Directed Electronics, Inc.