Avanti WC600CL - Manual (Page 6)

Important Safety Instructions
yWARNINCy To reduce the risk of fire, electrical shock,
or injury when using your appliance, follow
these basic precautions:____________________
Read all instructions before using the appliance.
DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not problems of the past. Junked or
abandoned appliances are still dangerous... even if they wilt “just sit in the garage
a few days, ’
Before you throw away your old refrigerator or freezer; Take off the doors.
Leave the shelves in place so that children may not easily climb inside.
Never allow children to operate, play with, or crawl inside the appliance.
Never clean appliance parts with flammable fluids. The fumes can create a fire
hazard or explosion.
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
of this or any other appliance. The fumes can create a fire hazard or explosion.
-Save these instructions- * •
INSTALLATiON INSTRUCTIONS
> Before Using Your Wine Cooler
• Remove the exterior and interior packing, including protective fiim on door panels and
digital display,
• Check to be sure the following parts are included;
• 7 slide out shelves (5 hold eight bottles and 2 hold six bottles)
■ 2 Keys
■ Instruction manual
• Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
> Installation of Your Wine Cooler
• Place your appliance on a floor that is strong enough to support the appliance when it
is fully loaded. To level your appliance, adjust the legs at the front of the appliance.
• For recessed installation allow Vг inch of space between the sides of the appliance as
well as the back and top. This will allow proper air circulation.
• Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extreme cold ambient temperatures may also cause
the appliance not to perform properly.
• Avoid locating the appliance in moist areas. Too much moisture in the air will cause
frost to form quickly on the evaporator,
• Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord.
Any questions concerning power and or grounding should be directed toward a
certified electrician or an authorized Avanti Products service center.