CLIFFORD 900-IQ - Manual (Page 13)

To transmit either channel 1, 2, 3 or 4: Just press either button 1, 2, 3 or 4. For
instance, to transmit channel 3, press button 3. While you transmit, the LED indicator
will blink once every second: this indicates level 1.
To transmit either channel 5, 6, 7 or 8: Press the LevelShift button once. This shifts
buttons 1-4 to level 2 (channels 5-8). Then press the desired button within the next 7
seconds. For instance, to transmit channel 5, press the LevelShift button once, then
press button 1. While you transmit, you’ll notice that the LED indicator blinks twice,
pauses, blinks twice, etc.: this indicates level 2.
To transmit channel 9, 10, 11 or 12: Press the LevelShift button twice. This shifts
buttons 1-4 to level 3 (channels 9-12). Then press the corresponding button within the
next 7 seconds. For instance, to transmit channel 10, press the LevelShift button twice,
then press button 2. While you transmit, you’ll notice that the LED blinks three times,
pauses, blinks three times, etc.: this indicates level 3.
NOTE: One second after you stop transmitting level 2 or level 3 (channels 5-12), the
remote control automatically returns to level 1 (channels 1-4).
What each button/channel does
Your IntelliGuard 900-IQ remote controls come pre-programmed so that certain
channels command certain functions. If you wish, you can actually assign any channel
except 9 through 12 to any function (see pages 21-25). The following chart indicates what
each remote control channel number does, and how to transmit each channel number.
Factory settings of the 12 remote control channels
Transmitting
channel
number:
Causes the system to:
Press the
LevelShift
button?
How
many
times?
Press
button
number
1 arm or disarm and lock or unlock the doors no — 1
2
turn on the headlights (if the system is armed)
AND
optionally pop the trunk (if the system is disarmed)
no — 2
3 silently arm or disarm no — 3
4 activate optional accessory function #1 no — 4
5 activate optional accessory function #2 yes once 1
6 activate optional accessory function #3 yes once 2
7 activate optional accessory function #4 yes once 3
8 activate optional accessory function #5 yes once 4
9 remotely enter or exit valet mode (see pages 15 and 16) yes twice 1
10 remotely turn off optional sensor #2 (see page 17) yes twice 2
11
remotely adjust sensitivity of the OmniSensor’s
primary zone (see page 17)
yes twice 3
12
remotely adjust sensitivity of the OmniSensor’s
warning zone (see page 17)
yes twice 4
12