Isdn usage commands, Isdn usage commands 544, Isdn u – Cabletron Systems CSX1000 User Manual
Page 544
USER’S GUIDE
544 CyberSWITCH
ipx trigreq [device]
Generates a triggered RIP/SAP update request to the specified device. You may use this
command to initiate an update request to synchronize with the routing database of a particular
WAN device.
ipx trigrip stats
Displays the triggered RIP statistics. Refer to
.
ipx trigsap stats
Displays the triggered SAP statistics. Refer to
ISDN U
SAGE
C
OMMANDS
The following commands are used to display and clear ISDN B-channel monitoring information.
isdn usage
Displays the following ISDN B-channel monitoring information:
•
The number of ISDN B-channels available.
•
The number of ISDN B-channels in use.
•
The high-water mark for the number of ISDN B-channels in use.
•
The value which the number of ISDN B-channels in use must meet or exceed in order to
cause an isdnUsageHigh SNMP trap to be generated by the system.
•
The enabled status for the generation of the ISDN usage traps (isdnUsageHigh and isd-
nUsageNormal).
•
The elapsed time since the monitoring of the high-water mark began.
This information can help you determine if additional lines and/or systems are necessary. For
example, the high water mark could be compared to the number of ISDN B channels available,
taking into consideration the elapsed time.
An example output from this command is as follows:
isdn usage clear
Clears the B-channel high-water mark and elapsed time values. The purpose of this command
is to allow the user to reset the high-water mark to coincide with changes to the system and/
or the network or so that the user can monitor the high-water mark over desired time periods.
[System Name]> isdn usage
number of ISDN B channels available:
6
number of ISDN B channels in use:
3
high water mark:
5
isdnBChanUsage trap threshold:
5
generation of ISDN usage traps:
enabled
elapsed time:
3 days, 4 hrs, 12 min, 38 sec