Aquapro Fish Feeders ATX - Manual (Page 4)

/1 pr Install the 8MM x %” bolts In the holes
^Oand Into the mounting bracket nuts in the
mounting bracket and tighten. (Illustration H)
1
(Illustration I)
*Note: make sure that there are no obstructions In
the feed disbursement area as this will effect the
performance of the unit. Examples: feeder legs,
solar panel, etc.
'I mounting bracket Is Installed
_LU reattach the directional power control unit
to the mounting bracket by simply aligning the slots
In the top of the unit with the retainer clips on the
mounting bracket and sliding until you hear, or feel
It, click Into place. (Illustration I)
17 Next, open the directional power control unit
and locate the timer. (Illustration J)
) Locate the motor wire harness that has four
)wlres on It and plug It Into the receptacle
located on the inside right hand side of the
directional power control unit box and gently push
until in place. (Illustration K)
^ QOnce step 18 is complete, find the
^ ^remaining two motorwires and attach the
Positive wire from the timer (white) to the Positive
wire from the motor, (white) (Illustration L)
PAGE 6 PAGE 7