Draining the unit – NewAir Portable Air Conditioner AC-10000E User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DRAINING THE UNIT
During the cooling process, some water will be extracted from the air and stored within
the unit’s water reservoir.
If the water reservoir is full, both the compressor and motor will stop and the unit will
beep (press any button to stop the beeping sound). The full water tank indicator light
will also start flashing.
To resume cooling, empty the reservoir by following these steps:
Turn off the air conditioner and unplug it
from the wail socket. To prevent water
leakage, avoid moving the unit when full.
2
.
Place a container (such as a small pan)
underneath the drainage port.
3. Remove the water plug from the drainage
port and allow the water to drain out.
4.
When the container is almost full, replace
the water plug back into the drainage port
and empty the water container.
5. Repeat until the water reservoir is
completely empty.
6. Replace the water plug back into the
drainage port and make sure it is firmly in
place.
7. Turn the unit back on. The warning signal
should turn off.
Drainage port
Water plug
Cap for the
water plug
FIG.17
1 1