AEG FAVORIT 665 - Manual (Page 17)

If you think your dishwasher is not working properly
• Are the strainers clean? Did you replace
the strainers properly after cleaning them?
• Have you used sufficient detergent?
• Check the drain hose (it must be run
according to the instructions given on
pages 20/21).
• In the event of a hot-water connection
(up to max. 60°C) — to ensure good
economy, only recommended if a cheap
supply of hot water is available — use
no 50° programmes so that the detergent
has a sufficiently long time to act.
the dishes do not dry and haVe
no sparkle?
• Have you used a branded rinse aid?
Is there enough rinse aid in the
dispenser? (check rinse aid indicator
on dosage combination).
Was the correct dosage selected?
In case of an overdosage:
If streaks, stripes, and milky shapeless
marks (also blue-coloured blooms) form on
the crockery, too much rinse aid is being
added. Therefore decrease the dose!
In case of an underdosage:
If dried water droplets (also greyish white
drop edges) form, especially on glasses,
too little rinse aid is being added.
Therefore increase the dose!
rust marks can be seen inside
the machine?
The machine interior, filters, and door
interior are made of stainless steel and
will not rust. If rust is found on these
parts, this must be from another source
(rust in water, rust particles from water
pipes, saucepans, and cutlery).
Remove the marks with a commercially
available stainless steel cleaner.
the drain pump runs continuously
(even when the machine is stopped)?
The water protection system (see page 21)
has responded.
First close the water tap and then unplug
the machine.
In this case, the service centre should
always be called for fault-finding.
17