Audiovox PRO92BTINT - Manual (Page 3)

8.
9
6. Move the valet/bypass switch on, then oH again.
7. The dash mounted LE.D. wiit flash 2 times, and the siren will 'chirp* one time,
indicating that the system is ready to accept programming for channel 2, or the
pulsed ground output for remote trunk release, remote car starter, etc.
You can assign any one of the two remaining button functions listed in 4a, 4b,
or 4c above to operate channel 2. You cannot use the button(s) that operate
channel f, selected in step 5, to operate channel 2.
Press and hold the selected choice. The siren will emit a long 'chirp' to confirm
that programming of channel 2 was successful.
10. Move the valet/bypass switch on, then off again.
11. The dash mounted LE.D. will flash 3 times, and the siren will 'chirp' one time,
indicating that the system is ready to accept programming for channel 3. (PS
301)
12. Press and hold the remaining transmitter button function. The siren will emit a
long 'chirp' to confirm that programming of channel 3 was successful.
13. To exit program mode, either turn the ignition key to the off position, or move the
valet switch on then off one additional time. This is indicated by a long 'chirp'
from the siren.
QUICK REFERENCE:
You can program any individual channel, without reprogramming all channels, by
following the quick reference chart below.
CHANNEL VALET SWITCH L.E.D,
1 ON then OFF 3 Times 1 Rash
2 ON then OFF 4 Times 2 Flashes
3 ON then OFF 5 Times 3 Flashes
After the desired channel is programmed, turn the ignition key to the off position to exit
programming mode.
128-4167A
3of 18