ASA Electronics CD3010X - Manual (Page 4)

JKMSEJN insiclllciuun
How to Install the CD3010X AM/FM Stereo
Radlo/Compact Disc Player with Remote
Control and Auxiliary input Jack
o. nwirmy
Wiring with a Wiring Adapter (Purchase Separately)
Wetcome!
For your Jensen stereo to work right, it must be installed correctly. This manual wKl show you how to
install your new Ijkn a pro It’S a good idea to read all of these instructions before you begin the
installation. Most Installaf/ans are straightforward and can be handled by a do-it-yourselfer with the right
tools and patience. But. do-it-yourself installation isn't for everyone. You may want to turn the installation
job over to an experienced installer.
Wprmnfy Servlet*
If your Jensen stereo should ever require service, you will need to have the original dated receipt. If you
ever need to return the unit for any
reason, always include the receipt with the product.
1. Before You Begin Installation
Tools and Supplies Needed Speaker Requirements
Wiring Diagram
• Torx type. Flat and Phillips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screw driver,
socket wrench set or other tools)
• Radio romoval tool for Ford care (oarly IflRfte
models and newer)
• Electrical tape
•Crimping tool
• Volt meterATest light
• Crimp connections
• 10 gauge wire for power connections
•16-18 gauge speaker wi re
Only connect the CD3010X to spoakere rated In
the load impedance range of 4 to 8 ohms.
Speakers with e load impedance less than 4
ohms could damage the CD3010X.
Disconnect Battery
Before you begin, always disconnect
the battery negative terminal.
2. Preparation
Radio
Remove Old Radio
Standard Bracket Mounted rr^M nnrlnp .Ippnt
-:f[|
1 ifi'
|F|)©
I j l j u A 1 1i l l A ©
Power Antenna
Connect to power antenna or amplifier, If not used,
tape bare end of wire.
Ground
Connect to ground terminal or clean, unpamted part
of chassis.
Mpmnry/Banery
Connect to battery or 12 volt power source that is
always alive.
77re radio will not work if this wire Is not
connected.
Acceesory^gnitlon
Connect to existing radio wire or radio fuse.
Fuai»s
When replacing a fuse, make sure new fuse is correct
type and amperage. Using an incorrect fuse could
damage radio. The C03010X uses one 10 amp fuse
located below wiring connector
• 10 amp fast blow ATO