Autostart AS-2370 - Manual (Page 3)

[Diagnostics - Parking Light Flash Table
Flashes Descri ption
1
• Doors locked, starter kill armed.
• Run time has expired.
• TRUNK button pressed.
• Start signal received by the module.
• Cold weather mode cancelled.
2
• Remote start attempt cancelled by
remote.
• Doors unlocked, starter kill disarmed.
• Exiting ignition valet.
• Exiting remote valet.
• Power-up reset
3
• Entering cold weather mode.
• Entering ignition valet. • Entering remote valet.
• Entering extended run time.
3 slow flashes^ ^after a failed start attempt The module did not detect a tach signal.
4
• +12 V detected on the brake input wire either while cranking or during run time.
• Entering multi-speed tach programming.
5 Slow ♦ Start attempt failed because no tach signal has been programmed.
5 Fast • Tach signal programmed.
6
• A remote start was attempted while a tach-before-crank signal was detected before
cranking.
8 • Unit reset: occurs when the unit is reset to the factory defaults
10 • A ground (-) signal was detected on the hood pin input wire.
1 —pause—
1—pause—
5 flashes
• Transmitter has been programmed.
[During the transmitter programming procedure]
1 - pause - 2
• There was a remote start attempt while the vehicle was in valet mode.
• Failed start: vehicle's low battery voltage.
on solid for 3
seconds^.
^followed by 1 flash Exiting cold weather mode
^followed by 3 flashes Entering cold weather mode
on continuously
• Idle mode: Idle mode is engaged
• Run time: The vehicle has been remote started and is in run time.
on continuously
While the
brake pedal »Confirms that cold weather mode is engaged
is pressed.
on 2 seconds
• The hood has been opened and a ground (-) signal has been detected on the hood
pin input wire.
on 4 seconds • Locking or unlocking a door (with Door pulses configured to 4 sec.)
on 20 seconds • The hood pin has been flashed and you are now in the programming centre.
Constant flashes
for 25 sec.
• Panic Mode is triggered.
P. 14 User Guide
Using the Rernote Control ___ __ _____________________
Your remote starter is equipped with a 5-button multi-channel remote control. It can operate two
independent vehicles equipped with a remote starter (see Multi-car operation section on page
10). The functions of the transmitter are as follows:
e
s
(S>
AUX.
LOCKt Ltlcb-lAi DA№nJ inns
rhf
KILL.
U'MtOCK; iMKtn ihi
.^IsanriK $TA4iTfft KItLr
AcAitei № AliX t eUEduf if
PrkrflE^ A h : i :№ \L
Uhf TRUNK w
jcU'bntfithe- AirX 3 outpuL
JTART/ITDP l RmiKjLc-jUlti'btafL CvU
WutFKr Modt by prasm^ 4h* SHIFT biicLcn
iTid ttiffi prflsinB hokihB
twp>n for } SMWifts-
SHIFTt
TWsljuctiMSiffVijjj j *«№<1 fgiWiiSTi
hjncfl. Ih COfntHrdOOP'MiAll Ite Odwr rC4Jr
btjUj:HU> hfltiHi
LO
difTcreni FirKticru tV th>7ve bvl^cvu.
Vehicle Presets
Heater S Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on high . It is recommended to leave the settings on low or medium
instead.
Windshield Wipers S Radio S Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are off . Leaving the headlight switch on on certain types
of vehicles could cause them to remain on even after remote starter shut down, resulting in a dead
battery.
Arming the Starter Kill
The Starter Kill (if installed) can be configured by the installer so as to arm automatically (Passive
Mode) or not to arm automatically (Active Mode).
• To disarm the Starter Kill, press the unlock button on the transmitter.
The parking lights will flash twice.
If remote door locks are installed, this will also unlock the doors.
• To arm the Starter Kill, press the lock button on the transmitter.
The parking lights will flash once.
If remote door locks are installed, this will also lock the doors.
• In Passive Mode , the Starter Kill will automatically arm if the ignition key is not inserted
Into the ignition switch within 1 or 3 minutes after unlocking (the key sense feature
must be installed).
User Guide P. 3