Adcom GTP-600 - Manual (Page 15)

2) Press the RC-65 Learn key © to enter Learn mode. Th6 Lesrn LED © glows steadily.
3) Press the proper RC-65 Input Selector button to identify the corresponding component. The Learn LED
blinks twice.
4) Press the RC-65 command key you wish to program. The Learn LED blinks once.
5) Press and hold the corresponding key on the other remote until the RC-65 Learn LED blinks twice. The
Learn LED then resumes steady operation.
A prograrnming error is indicated by simultaneous operation of Learn and Transmit LEDs. If this happens,
repeat steps 3 through 5 as needed.
6) Repeat steps 3 through 5 above for all other desired commands.
7) When finished, press the Learn key to exit Learn mode. The Learn LED goes out.
C) To delete previously programmed commands (except non-erasable ADCOM commands):
1) Press the RC-65 Learn key © to enter Learn mode. The Learn LED © glows steadily.
2) Press the proper RC-65 Input Selector button to identify the corresponding component. The Learn LED
blinks twice.
3) Press the RC-65 Reset button ©. The Learn LED blinks continuously.
4) Press the RC-65 command key you wish to clear. The Learn LED stops blinking & resumes steady
operation.
Note: You can delete an entire bank of buttons (all command keys associated with a particular Input
Selector) at once by pressing the appropriate Input Selector again.
5) Repeat steps 3 & 4 as desired.
6) Press the Learn key to exit Learn mode. Learn LED goes out.
ADVANCED OPERATION
26) SYSTEM BALANCING: Accurate balancing enhances the spatial accuracy of your audio/video playback system
by matching the acoustic levels of all system speakers in your room as closely as possible. Once you’ve done
this, any level differences from left to center or from center to rear, etc., are differences intended by the creators of
the original soundtrack, not some unwanted aberration caused by the acoustics of your room.
EVERY ROOM IS ACOUSTICALLY DIFFERENT AND THE RELATIVE CHANNEL-TO-CHANNEL LEVELS WILL
CHANGE AS YOU MOVE AROUND THE ROOM. THIS MEANS THAT YOU SHOULD PERFORM THE BALANCE
CHECK WHILE SEATED IN YOUR FAVORITE LISTENING/VIEWING LOCATION. That’s why we’ve included the
necessary center, rear, and subwoofer level adjustments ONLY on the RC-65 hand held remote controller.
A) Activate the ’’Balance check" circuit: Push the Bal check button © An internal signal generator interrupts
the normal audio information and sends a test tone to all loudspeakers sequentially. The test tone is a filtered
broadband signal close in overall balance to the normal distribution of tones encountered in real life.
The tone generator will “step” through all speakers sequentially beginning with the left front. After two seconds
of left front output, the tone will shift to the center channel.
B) Use the “Center level Up/Down" buttons ©to adjust center channel output to match left channel volume as
closely as possible.
C) After approximately two seconds, the center channel will mute and you’ll hear the test tone through the right
front speaker, probably at the same level as that of the left channel. If this is the case, do nothing.
If there is a substantial difference between left front and right front outputs, correct the difference with the
GTPSOO’s balance control®
Significant placement differences for left and right front speakers may cause
this imbalance: Ideally, they should be spaced symmetrically on either side of the TV screen. If room decor
makes this placement difficult, or if you prefer to sit off-center from the TV screen, you may need left-right
balance correction.
13