Audiovox ACA250 - Manual (Page 6)

Wiring tht Camera to the Vehicle'» Reverse Lamp
1. Locale the reverse lamp in the tail light assembly.
2. Using the tap connector supplied, perform the following steps:
a) Place the un«siripped positive lead from the tail lamp in the run
channel, which runs completely through the connector.
b) Insert the un*strippcd red power wire from the camera completely
into the other channel in the connector.
c) Make the connection between the wires by crimping down the metal
connector with a pair of pliers, making sure the metal is flush with
the plastic insulator.
d) Close the top plastic hinged cover until latched.
3. Attach the black wire from the camera to the negative lead of the lamp
by repeating the abo%'c procedure.
Testing the System
Operating the System
The Wireless Vehicle Rear Observation System operates when the
vehicle is shifted into reverse. The Camera transmits a clear and wide
image from the area behind the vehicle to the Monitor inside the vehicle.
The monitor, when powered, remains in sleep mode until it receives a
video signal on the 2.4GHz fretjuency. When the monitor receives a
video signal, it automatically turns on and displays the image from the
camera.
The monitor automatically adjusts for color, brightness, and contrast, for
either daytime viewing or night time viewing. There arc no user
selectable adjustments.
In conditions such as at night, the camera will automatically switch to
Night Vision Assisted Mode. The picture will look more like a Black &
White image, this is due to the low light level and is normal.
Note: Because this is a wireless system, the monitor is always watching
fora video signal. It is possible to receive signals from other cameras.
Systems such as Security camera's. Baby monitors, and even other Back
up camera systems can trigger the monitor to briefly turn on. This is
normal for wireless products.
To test the Wireless Vehicle Rear Observation System installation,
perform the following steps:
1. Set the parking break.
2. Start the vehicle.
3. Shift the vehicle into reverse.
4. Verify that the monitor displays the image from the rear camera.
If the monitor does not operate, refer to the trouble shooting section of
the manual.
ISgecifications
GeaernI
Power Supply DCI2V
Power Consumption <dW
Correat Draw <400 mA
Opera ting Tempers lure Range Otto sox:
Fuse 2 Amps
Display System
Screen 2.5* LCD Color
Night Vision IR LED Assisted
Brightness 400 Cd/H*
Contrast Ratio l$0:l
Backlight Life 10000 hours
Resolution 000X234
Video Fomat NTSC/PAL
Display Formal 16:0
Wireless Reception System
Operating Frequency 2.4CHZ