ASKO 7304 - Manual (Page 4)

3 Select
Automatic program
4 Select dryness
or
Timed program 4 Press the hour-glass button until
you can see the required time in
the window.
QQ
oo
I
Which program should I use?
The program to use depends on what you want to do with the washing after tumble-drying. There are four automatic programs
- Extra Dry, Dry, Damp Dry and Iron Dry - and a timed program, allowing you to determine the drying time yourself.
The pushbutton controls
Extra dry: When you want extra dry fabrics: This automatic program is intended for use with washing that
is extremely difficult to dry, i.e. jeans with very thick seams. The heat is turned off when the washing is
m
completely dry, and is followed by a cooling period of about 15 minutes.
Dry: For "ready-to-wear" dryness: This program turns off the heat when the washing is dry but not absolutely
bone-dry. It is then cooled for about 15 minutes. This is the program to use when you want dry fabrics.
Damp Dry: This program is intended to leave a small amount of moisture in the clothes to allow small wrinkles
to fall out when hung-up.
Iron Dry: For fabrics to be ironed: This program turns off the heat when the washing is just damp enough
for ironing.
Program Start/Stop: You can stop any program at any point by pressing the Stop pushbutton for three seconds.
End of Cycle Signal: Press this button for a warning buzzer to sound when the program is finished. One hour
after the end of the program the buzzer will sound once a minute. At the same time the cylinder will rotate
to prevent wrinkling.
Anti-Crease: To help prevent wrinkles, this cycle enables the machine to tumble for three seconds every minute
for one hour, or will stop if the clothes are removed before the hour has ended.
Low Temp: Use this button if low temperature is required.
Setting the time for the timed program; Press the TIME pushbutton. The machine responds by displaying
5 minutes in the window. By pressing the time pushbutton, you can increase the time in 5-minute intervals
10-15-20. After 20 minutes, the time increase is by 10 minute-intervals 30-40-50-60-70-80-90. All timed
programs are followed by an automatic 15 minute cool down period.
The timed program is automatically set
for low temperature. However, normal can be used by pushing the
low temperature button one time. The light in the button will go out signifying normal temperature.
To air fabrics; Use the unheated program, which you obtain by pressing the time pushbutton until C appears
in the display. This program can not be combined with any other program. Use this program to shake the dust
out of garments, or to fluff them up.
Time-delayed start: Press thel ^ Ipushbutton to set a starting time delay of 1-12 hours. Each time you press
the button, a further hour’s delay will be added and displayed.