Associated Equipment 73-800 - Manual (Page 4)

ASSEMBLY INSTRUCTIONS
4, Mount the hose assembly to the unit Using the cotter pin
supplied, attach the shaft of the hose swivel from Inside the
1 . Removethecastercarton.andthehozonozzlecartonfrom „nft. ^
Inside the unit Uttchthedoorciosedandcareiultylay the unit
on Hs skfe,
'
Í -J
2. Assembie the casters to the undersWe of the unit with the
sixteen (16) 1/4* - 20 hex head bolls, lock washers and flat
washers provided. Mount the swfwi casters toward the vac­
uum gpoe end of the unit
3, Turn the unit upright and k>ck the swivel casters.
Snp the end of the hose over the nozzle and secure it in place
wfttt the supplied band damp.
Bmna
Puil the black rubber swivel seal up from the hose mounting
base to cover the gap between the swfvel base and the hose
swfveL
3. Assemblé the nozzle to thé annusit>g two 1/4'-20X2' hex
txilts, four flat washers, four lock washers, and four hex nuts.
Make sure that the nozzle opening points down (toward the
Inside of the Jolxrt arc).
5. Install the fUters
NOTE: THEFUOWDIRecnONARROWSONTHERLTER
FRAMES. MAKE SURE THATTHE ARROWS PQ1^П^.
TOWARD TREBLOW^ ^
• '• r . J-
j
" m -DUAL ARM y^OPJION
To Install the second arm, proceed as follows;
1. Remove the Wank plate covering the secofKi hola. Save
the hardware.
2. Using the hardware removed in Step 1 above. Install the
second collar to the unit.