Aiwa ADC M55YU - Manual (Page 5)

INSTALLATIONS
Precautions
Select the mounting location very carefuily,
referring to the following points.
• Make sure that there is no fuel tank, wiring or
piping on the other side of the mounting surface.
• Make sure that the instaliation of the unitwill not
hinder the movement of the deck iid or interfere
with the spare tire, etc.
• Use only the supplied mounting kit for safe and
proper instaliation.
Removing the transport screws
Find the three transport screws at the bottom of
the unit, which lock the unit's mechanism during
transport. Remove these screws before
installation.
Retain these screws and replace them in the
originai positions if the unit is transported for
service or maintenance.
Mounting angie setting ievers
Be sure to change the position of both mounting
angle setting ievers according to the angie at
which the unit is to be installed.
Mounting angle setting levers
Insert a pointed object such as a screw driver or
ball-point pen, etc. Into the low spot of the lever
and slide the lever to the position from among H
(horizontal), 45°, and V (vertical) positions.
Notes
• Be sure to eject the disc magazine when you set the
levers.
• Be sure to set both levers to the same position.
• Be sure to set the levers exactry at the position (notch).
If the lever is deviate from the position, the sound may
drop out.
• Care must be taken when you mount the unit at the
angle of lowerthan level. The disc magazine may drop
If you eject the magazine.
• Do NOT turn over the unit or slide the lever when the
unit is activated. Doing so may damage the mechanism
or the discs in the unit.
• The mounting angle setting levers on each side of the
unit are factory-set to the H (horizontal) position.
• When you complete the setting, attach the supplied
adhesive labels (D over the slots.
ENGLISH
4