Agri-Fab 7 cu ft. Farm/Garden Cart 45-01761 - Manual (Page 2)

RULES FOR SAFE OPERATION
Preventing accidents is the responsibility of every
equipment operator. The following general safety
precautions must be fully understood and followed
by every operator.
1. Do not at anytime carry passengers in this cart.
It is designed for carrying materials only and not
intended to carry passengers.
2. Be careful on any grade (hill) and stay off of
steep grades.
3. Use caution when loading cart to avoid tipping.
4. Avoid large holes and ditches when transporting
loads.
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
(1) Screw Driver
(1) Pair of Pliers
(1) 7/16" Operi End or Box Wrench
When assembling your cart, place the heads of all
screws to the inside and hex nuts with flat washers
outside.
1. Lay the front angle assembly down (flat) on floor
and stand the bottom panel in position as
shown in figure 2.
Your Farm/Yard Cart carton contains a hardware
package with parts as shown in the chart below and
figure 1.
Contents of Hardware Pack: (See figure 1)
REF.
NO.
QTY. DESCRIPTION
A 13 Screws, 1/4-20 x 3/4" Long
B 25 Flat Washer 1/4" I.D.
C 25 Hex Nuts 1/4-20 Thread
D 8 Screws, 1/4-20 x 1-3/4" Long
E 2 Cotterpins
F 4 Flat Washers 25/32" I.D. x 1-1/2;;
O.D.
G 4 Screws 1/4-20 x 1" Long
H 6 Rubber Cap 1/4" x 3/8" Lg.
1 4 Tube Cap 1" x 1" Lg.
HARDWARE REFERENCE CHART
NOTE
The bottom panel has one galvanized
edge, this is the rear. The front edge
has three holes. See figure 2.
FIGURE 1.
Line up three holes in bottom panel with holes
in front angle assembly. Start three 1/4" x 3/4"
truss head screws through bottom panel, then
through angle. Secure screws with flatwashers
and hex nuts. See figure 2. Tighten securely.