ASKO 7005 - Manual (Page 10)

Changing the door hinging...
Switch off the main power supply first!
Tools: Phillips screwdriver, 10 mm wrench.
1. Remove the lower panel A.
2. Unscrew the upper screw B + C.
3. The upper hinge is now loose. Raise the door a little
so that it comes away from the bottom hinge. Remove
the top hinge.
4. Move the hinge pin J to the other hole in the hinge
using 10 mm wrench.
5. Push out the hinge bearings from the old holes in the
door.
6. Take the door apart by removing all screws which are
around the edge of the door.
7. Undo magnet cap D.
8. Remove the cover washer from the magnet position E
on the other side.
9. Screw the magnet tight at E (spring plus washer plus
screw) and insert cover washer in the hole at D.
10. Screw the door together.
11. Remove the plug from the new hole for the hinge at
the upper edge of the door at H. Insert this plug in the
old hinge hole.
12. Knock out the hole at the lower hinge hole K using a screwdriver. Insert the plug supplied in the old hinge hole.
13. Fit the hinge bearings in the new hinge hole.
14. Unscrew the lower hinge and move the hinge pin as shown in item 5 above.
15. Remove the plastic protection at F and G and place this where the hinge was previously fitted.
16. Tighten the top hinge.
17. Screw in screw B for the bottom hinge a few turns.
18. Insert the lower hinge pin in the door hole. Place the door's top hinge hole on the upper hinge pin. Place the door and
the lower hinge in position in screw B that has already been fitted. Screw in screw C.
19. Adjust the lower hinge so that the door hangs straight. Tighten screws B and C.
20. Refit the lower panel.
Eiectricai instaiiation
The machine is delivered ready-fitted with
a plug, and is interKfed for connection to a
single-phase siqiply. The supply must be
earthed. If the machine is to be ised in a
wet area, the supply must be protected by
a residual current device.
Connection to a permanently wired supply
point must be made only by a qualified
electrician.
As supplied: 1 -phase, 208-240 V, 60 Hz
2850 W heater rating,
30 A fuse required
NOTE: On rear of the machine there is a receptacie oniy
dedicated ASKO washing machines, rated 208-240 V.
in use of this recepUttie, deihrered ready-fitted piug or an equai
must be used. The suppiy connection must be 208-240 V, 30 A.
ASKO washing machines rated 208-240 V have an intemai fuse of
15 A.
GROUNDING INSTRUCTiONS
This appliance must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric
shock by providing a path of least resistance for electric current This appliance is equipped with a cord having an
equipment-grounding conductor and a grounding piug. The piug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local codes and ordinances.
WARNING - Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check
with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly grounded.
Do not modify the plug provided with the appliance - if it will not fit the outlet, have a proper outlet installed by a
qualified electrician.
10