Avanti DGR-210 - Manual (Page 11)

A WARNING.!?
DO NOT ATTEMPT TO OPERATE ANY SURFACE BURNER WITHOUT
INSTALLING IT. OTHERWISE, THERE IS A RISK OF EXPLOSION.
• First, the surface burners must be installed correctly, as seen in Figure 7.
• The ring and its cap must be in its place. The burners should be level with the surface of
the main top.
• The cookware supports must be in their places on the cook top. These plastic rings are
already in place and are used to prevent rocking as shown in Figure 8. Use stable
cookware with a flat bottom and always place the utensils on the cookware supports before
lighting the burner.
• The surface burners are controlled by knobs located on control panel at front side of the
appliance, as seen in Figure 9.
• There is a symbol over the knob on the control panel to identify which knob controls which
burner. Also, there is a symbol indicator on the knobs, to aid in setting the burner to the
desired temperature.
> To Light the Desired Surface Burner
• Push the control knob in.
• After the burner ignites, turn the knob counter-clockwise without releasing it to adjust the
flame size. Then release the knob.
• For maximum heat output, align the large flame symbol on the knob with the vertical line
on the control panel. In order to decrease the heat output, turn the knob in the direction of
the small flame symbol. For minimum heat output, align the small flame symbol on the
knob with the vertical line on the control panel.
• The amount of food being cooked, the amount of liquid, or the size of the pan should
determine the heat settings. Always position the utensil on the burner grate before lighting
the burner. For your safety, the flame should not extend beyond the sides of the pan. Any
flame larger than the bottom of the cookware is wasted and only heats the handle.
• To turn the burner off, turn the knob clockwise until it reaches the (•) symbol,
•
Before lighting a burner. Make sure all grates on the range are in place before using
any burner.
• After the burner ignites, turn the knob to adjust the flame size. Watch the flame not the
knob, as you adjust the heat.
• In case of power failure.
• You can light the surface burners on your range with a match. Hold a lighted match to
the burner, and then turn the knob to the ON position. Use extreme caution when
lighting burners in this manner.
• Surface burners in use when an electrical power failure occurs will continue to operate
normally.
NOTE; The electrode of the spark igniter is exposed. When one burner is turned to ON, all the
burners spark. Do not disassemble or clean around any burner while another burner is on. An
electric shock may result, which could cause you to knock over hot cookware.