Compex WP54AG User Manual
Page 72
61
W
W
A
A
N
N
S
S
E
E
T
T
U
U
P
P
(only supported by Wireless Routing Client and Gateway)
A correct WAN Setup allows you to successfully share your Internet connection
among the wired and wireless clients of the access point. To do so, you need to
identify the type of broadband Internet access you are subscribed to. If you are
using :
x
Cable Internet where the ISP dynamically assigns a WAN IP address
to you,
refer to WAN Setup - Cable Internet with Dynamic IP Assignment.
x
Cable Internet where your ISP provides you with a fixed WAN IP address
(or
a range of fixed IP addresses), refer to WAN Setup - Cable Internet with
Static IP Assignment.
x
ADSL Internet that requires standard PPP over Ethernet (PPPoE)
for
authentication, refer to WAN Setup - ADSL Internet using PPP over Ethernet
(PPPoE).
x
ADSL Internet that requires standard Point-to-Point Tunneling Protocol (PPTP)
for authentication, refer to WAN Setup – ADSL Internet using Point-to-Point
Tunneling Protocol (PPTP).
WAN Setup - Cable Internet with Dynamic IP Assignment
The access point is pre-configured to support a WAN type that dynamically
obtains an IP address from the ISP. However, you may verify the WAN settings with
the following steps:
Step 1:
Under
C
C
O
O
N
N
F
F
I
I
G
G
U
U
R
R
A
A
T
T
I
I
O
O
N
N
on the command menu, click on
W
W
A
A
N
N
S
S
e
e
t
t
u
u
p
p
.
S
S
t
t
e
e
p
p
2
2
:
:
On the
W
W
A
A
N
N
D
D
y
y
n
n
a
a
m
m
i
i
c
c
S
S
e
e
t
t
u
u
p
p
screen that follows, verify that the
W
W
A
A
N
N
T
T
y
y
p
p
e
e
reads
D
D
y
y
n
n
a
a
m
m
i
i
c
c
(
(
D
D
H
H
C
C
P
P
)
)
in red colour. Otherwise, click on the
C
C
h
h
a
a
n
n
g
g
e
e
button.