Ariston fm81r ix aus - Manual (Page 8)

- Using the oven for storage purposes;
- Using flammabie iiquids near the appiiance;
- Using adaptors, multiple sockets and/or extension cords;
- Attempting to instaii or repair the appliance without the
assistance of quaiified personnel.
Qualified personnel must be contacted in the following
cases:
- Installation (following the manufacturer's instmctions);
- When in doubt about operat'ng the appliance;
- Replacing the electrical outlet when it is not compatible
with the plug for the appliance.
Service Centres authorized by the manufacturer must
be contacted in the following cases:
- If in doubt about the soundness of the appliance after
removing it from the packaging;
- If the power supply cord has been damaged or needs to
be replaced;
- If the appliance breaks down or functions poorly; ask for
original spare parts.
It is a good idea to do the following:
- Only use the appliance to cook food, nothing else;
-
Check the soundness of the appliance after it has been
unpacked;
- disconnect the appliance from the electrical mains if it is
not functioning properly and before cleaning or performing
maintenance;
- When the appliance is not used for an extended period
of time, cut off the supply of power and close the gas
cock (if present);
- Use cooking gloves to place cookware in the oven or
when removing it;
- Always grasp the oven door in the centre because the
ends may be hot due to the escape of hot air;
- Make sure that the control knobs are on the o" setting
when the appliance is not in use;
- Cut the power supply chord after disconnecting it from
the mains when you decide not to use the appliance any
longer.
• The manufacturer will not be held liable for any damages
that might arise out of incorrect installation or improper,
incorrect or unreasonable use of the appliance.
Installation
Important: The power supply to the appliance must be
cut off before any adjustments or maintenance work is
done on it.
Installation of Built-in Ovens
In order to insure that the built-in appliance functions
properly, the cabinet containing it must be appropriate.
The figure below gives the dimensions of the cutout for
installation under the counter or in a cabinet wall unit.
In order to ensure adequate ventilation, the back panel of
the cabinet must be removed. Installing the oven so that it
rests on two strips of wood is preferable. In the case where
the oven rests on a continuous, flat surface, there must
be an aperture of at least 45 x 560 mm.