Dicota Phasor - Manual (Page 4)

4
Installing the batteries
Step1: Press the button on the Phasor and pull the battery cover back-
ward.
Step 2: Insert the batteries as shown inside the battery compartment.
Step 3: Replace the cover.
Install the receiver
It needs to be plugged into your computer or Notebook via the USB port.
Phasor is a Plug and Play device. Normally, it’s not necessary to setup
the RF Channel. But if some interference happens, then you should
please setup the connection RF Channel.
Connect to the USB of your Notebook or computer
Hold
Pull
1. 2.