Ashly Compressor/Limiter CL-52 - Manual (Page 2)

Specifications
CONTROLS
stereo tie switch
defeat switch
gain:
ratio:
attack time:
release time:
output:
Detector Patch Point:
Maximum Input/Output Level:
Input Impedance:
Output Impedance:
Frequency Response:
Distortion:
Hum and Noise:
Power Requirements:
Size:
Shipping Weight:
Block Diagram
Many interesting and productive effects can be
achieved by combining the CL-50E or the CL-52E with
Ashly’s SG-33E or SG-35E Noise Gates.
(CL-52E ONLY)
±30dB
2:1-<»
200 m S. - 20mS.
lOOmS - 2Sec.
-40dBV - +20dBV
allows the connection of an EQ for
frequency selective limiting
+20dBm
lOkQ balanced bridging
50ii term, w/ 600£2 or more
±.2dB 20Hz - 20kHz
<•015% THD, OdBV 20 Hz • 20kHz, no limiting
<•15% +i8dBV worst case
-95dBV unity gain
120 VAC, 50-60HZ, 5W
19" L
X 1 3/4"H X 6"D
8lbs
Architect’s Specification
The unit shall be a single (CL'50E) or dual (CLr
52E) channel compressor/limlter with indepen­
dent attack, release and ratio adjustments. It
shall have detector patch points which allow con­
nection of an external equalizer in the detector
loop to produce frequency selective limiting. It
shall have front panel mounted switches for
engaging/ defeating the compressor/llmiter func­
tions. Performance specifications of a typical
production unit shall meet or exceed the follow­
ing: Gain control shall be +30dB. The ratio shall
be adjustable from 2:1 to «. The attack time shall
be adjustable from 200^iS to 20mS. The release
time shall be adjustable from lOOmS to 2 sec­
onds. The output shall be adjustable from -40dBV
to ■i-20dBV. The maximum in-out level shall be
+20dBm, The input impedance shall be lOkii bal­
anced bridging. The output impedance shall he
50£2 terminated with 60011 or more. The frequen­
cy response shall be 20Hz to 20kHz l.ZdB.
Distortion shall be <.015% THD @ OdBV from
20Hz to 20kHz with no limiting, <.15% @4^1SdBV
worst case. Hum and noise shall not exceed -
90dBV @ unity gain. The unit shall operate at
115VAC ±5%. 50-60HZ. The unit shall be
designed for mounting in a standard ElA 19'' rack
(19'"L X 1.75"H X 6"D) and shall have a shipping
weight of 8 lbs. The imit shall be either a model
CL-50E (single channel) or a CL-52E (dual chan­
nel) Compressor/Limiter manufactured by Ashly
Audio Inc. No other unit shall be acceptable
unless submitted data from an independent
research lab verifies that the above slze/perfor-
mance specs are met.
Ashly Audio Inc.
ASHLY
Since 1972
© 1990 Ashly Audio