Beko B 1901 - Manual (Page 9)

Installation
S Please remember that the
manufacturer shall not be held liable if
the information given in the instruction
manual is not observed.
Preparation
• Your refrigerator should be installed at
least 30 cm away from heat sources
such as hobs, ovens, central heater
and stoves and at least 5 cm away
from electrical ovens and should not
be located under direct sunlight.
• The ambient temperature of
the room where you install your
refrigerator should at least be 10°C.
Operating your refrigerator under
cooler conditions than this is not
recommended with regard to its
efficiency.
• Please make sure that the interior
of your refrigerator is cleaned
thoroughly.
• If two refrigerators are to be installed
side by side, there should be at least
2 cm distance between them.
• Original packaging and foam
materials should be kept for future
transportations or moving.
3. Packaging must be tied with thick
tapes and strong ropes and the
rules of transportation printed on the
package must be followed.
Please remember...
Every recycled material is an
indispensable source for the nature
and for our national resources.
If you wish to contribute to recycling
the packaging materials, you can
get further information from the
environmental bodies or local
authorities.
Before operating your
refrigerator
Before starting to use your refrigerator
oheok the following:
1 - is the interior of the refrigerator dry
and can the air circulate freely in the
rear of it?
2- Clean the interior of the refrigerator as
recommended in the “Maintenance
and cleaning” section.
3- Plug the refrigerator into the wall
outlet. When the door is open the
respective interior light will come on.
Points to be considered
when re-transporting your
refrigerator
1
.
2.
Your refrigerator must be
emptied and cleaned prior to any
transportation.
Shelves, accessories, crisper and etc.
in your refrigerator must be fastened
securely by adhesive tape against any
jolt before repackaging.
8 I EN