DYSON DC14 - Manual (Page 6)

Using your DC14
6
Tools
A Push back wand cap.
B Pull wand from inside
wand handle until it clicks
into place.
Using your DC14
WARNING
•The machine is intended
for domestic use only.
•Fine dust such as plaster
dust or flour should only
be vacuumed in very
small amounts.
CAUTION
•Do not press the
cyclone release button
while carrying the
machine, or it could
fall and cause injury.
•Ensure the cyclone pack
is secured to the machine.
•Do not shake the
machine while carrying,
or it could fall and
cause injury.
•Keep hair and loose
fabrics away from wand
cap when machine is on.
•Use machine in bare
floors mode for bare or
delicate flooring, rugs,
and carpets.
•Ensure the machine
is in an upright
position before
adjusting the setting.
After plugging machine into
electric outlet, press on/off
button A, push cleaner head
down with foot and pull
handle towards you.
A
B
C
A
A
B
Brush control system
A Bare floors: Use this setting
to stop brushbar from turning
when vacuuming bare
or delicate flooring, rugs,
and carpets.
B Carpets: Use this setting so
brushbar turns when vacuuming
non-delicate surfaces.
tip The brushbar will not turn until
you tilt the handle backwards
to begin vacuuming.
Dyson Helpline contact us at 1-866-693-9766
D
Consult your flooring manufacturer’s recommended instructions before vacuuming and caring
for your flooring, rugs, and carpets. Some carpets will fuzz if a rotating brushbar is used when
vacuuming. If this happens, we recommend vacuuming in bare floors mode and consulting
with your flooring manufacturer.
C Press button to release
hose and wand handle from
machine.
D To push wand back inside
hose, ensure hose is straight.
Press the same wand release
button and push wand back
inside wand handle
.
18690_DC14_US_OPS_MAN 8/23/07 9:53 AM Page 6