3DLABS Wildcat 4210 - Manual (Page 30)

23
4. If you are prompted with the following message: “The selected monitor cannot display
the current desktop area. Select a new resolution before applying these changes,” click
OK then select a resolution from the list of available resolutions.
5. Click OK if the display is correct and you wish to keep the new settings. The Display
Properties dialog box is dismissed.
6. Click OK to accept the new display mode and dismiss the Display Properties dialog box.
NOTE: You must disable stereo mode when you no longer wish to view in stereo. Follow the steps
above, and select Monoscopic Display under Display Mode to disable stereo mode.
Enabling Multiview and Genlock
The Intense3D Wildcat 4210 features Multiview support for frame locking and rate locking of multiple
workstations. Genlock support allows video timing to be synchronized to an external timing source.
NOTE: Your application must support Multiview for Multiview to work.
To prepare workstations for Multiview:
1. Insert one end of a shielded RJ12 cable into the Multiview Out port (Figure 10) of the
first workstation (Figure 10). This workstation becomes the “Master”
NOTE: Refer to the Intense3D support website (www. http://www.intense3d.com/support.asp) for
information on ordering the correct cables.
2. Insert the other end of the cable into the Multiview In port of the second workstation.
This workstation becomes a “Slave.”
3. If connecting more than two workstations, continue linking workstations to one another
by connecting the Multiview Out port of one workstation to the Multiview In port of the
next. The last workstation should terminate the links and only have a cable plugged into
the Multiview In port.