3DLABS Permedia3 User Manual
Page 2
Copyright 1999 by 3Dlabs, Inc.
3Dlabs and Permedia are registered trademarks of 3Dlabs, Inc. or 3Dlabs Inc. Ltd. Pentium is
a registered trademark of Intel. OpenGL is a registered trademark of Silicon Graphics, Inc.
Colorific is a registered trademark of Sonnetech Ltd. Microsoft and Windows NT are
registered trademarks of the Microsoft Corporation. All other trademarks and registered
trademarks are the property of their respective holders.
C
AUTION
:
Changes or modifications to the Permedia3 Create! graphics accelerator card not
expressly approved by 3Dlabs, Inc. void the user’s warranty.
FCC Notice:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy. If product is not installed
and used in accordance with the instruction manual, it may cause harmful interference to
radio communications; however, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
1.
Re-orient or relocate the receiving antenna.
2.
Increase the separation between the equipment and receiver.
3.
Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
4.
Consult 3Dlabs or an experienced radio/TV technician for assistance.
Compliance with FCC Rules requires that a shielded cable be used to connect to other
equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2) this
device must accept any interference received, including interference that may cause undesired
operation.
This Class B digital apparatus meets all the requirements of the Canadian Interference-
Causing Equipment Regulations. Cet appareil numérique de la classe B respecte toutes les
exigences du Règlement sur le material brouilleur du Canada.
3Dlabs, Inc. makes no representation that the use of its products in the manner described in
this publication will not infringe on existing or future patent rights, nor do descriptions
contained in this publication imply the granting of licenses to make, use, or sell equipment or
software in accordance with the description.
June 3, 1999, Rev. A