Acoustic Image Series4 - Manual (Page 9)

System (all models)
Amp Head
Frequency Response 30 Hz-18 kHz (40-14 kHz ±3 dB)
50 Hz-
kHz (60-1 kHz ) Corus
Max SPL >112 dB at 1 meter,
(Corus), >118 dB/m (Ten2)
AC Power 100-115V/50/60 Hz or 220-240V/50 Hz,
switchable,
Size 12”Hx15”Wx13”D (Coda, Corus, EX)
Weight 22 lbs (Coda, Corus, 19 lbs (EX)
32 lbs (Ten2), 25 lbs (EX)
4 lbs (Clarus)
Frequency Response 20 Hz - 20 kHz (
Mic Input 600 ohm balanced, XLR connector,
switchable 10 dB pad
Phantom Power 48 volts, on/off switch w/LED indicator
Instrument Input 1 M impedance, 1/4 inch jack
Direct Out +4 dB, balanced, XLR connector, ground
lift, pre/post EQ selector
Effects Loop Parallel type with return level control
Bass Control Shelving type, ±15 dB at 60 Hz
Mid Control ±15 dB at 650 Hz
Treble Control Shelving type, ±15 dB at 10 kHz
Low Cut Filter -12 dB/octave sweepable from 30 to 400
Hz
Phase Reverse Switchable 180 degree phase reverse
Type Digital with 6 presets and level control
Program Presets 3 reverb (hall, room, plate), delay,
ambient chorus, flange
Topology Class D (PWM)
Switching Frequency 500 kHz
Output Power 8 300W rms continuous, 350W rms music,
500W peak transient
External Speaker Output Neutrik Speakon type (pole 1), 2 min
load including internal speakers, if
connected
18 4 ±3 dB
>115 dB at 1 meter
17”Hx15”Wx13”D (Ten2), 14”H (EX)
10”x8”x3.5” (Clarus)
±0.5 dB)
Output Power 4 500W rms continuous, 650W rms music,
1000W peak transient
Preamp (Mic and Instrument Inputs through combo jack)
Effects
Power Amp
W
W
W
W
14
Specifications
Speaker System (Coda, Corus)
Speaker System (Ten2)
Shoulder Strap
Woofer 10 inch, downfiring
Midrange 5 inch, forward firing with 2 position level
control switch
Crossover Passive, alignment corrected
Impedance 8
Power rating 250W
Woofer Dual 10 inch, one downfiring with level
control, one forward firing
Tweeter 2.5 inch forward firing with attenuation
control
Crossover Passive, alignment corrected
Impedance 4
Power rating 500W
Fitted slip cover with cord storage
pocket and shoulder strap (combo
amps)
Gig bag with shoulder strap, Speakon
to 1/4 inch adapter (amp heads)
Padded gig bag with shoulder strap
made by Mooradian, kit to convert
cabinet with head removed to an
extension cab (adapter, filler panel,
padded case for head)
To use the shoulder strap to transport a combo amp, feed the strap
through the handle opening on the speaker cabinet (both sides) and
clip the end to the D-ring attached to the strap. The picture below
illustrates how to attach the strap. The strap can be used either with
the slip cover in place or not in place.
W
W
Supplied Accessories
Available Accessories
15