Acoustic Image Series II - Manual (Page 6)

9
System (all models)
Frequency Response
30 Hz - 20 kHz, (40 - 16 kHz ± 3 dB)
Max SPL >112 dB at 1 meter
AC Power 115V/60 Hz or 230V/50 Hz, switchable
Size 12” H x 15” W x 13” D
Weight 27 lbs, 23 lbs (New Yorker), 22 lbs (EX)
Preamp (Mic and Instrument Channels-as appropriate to model)
Mic Input
600 ohm balanced, XLR connector
Phantom Power 38 volts, on/off switch
Instrument Inputs Low impedance (1 M Ω ),
High Impedance (10 M Ω ), separately buffered
Direct Out +4 dB, balanced, XLR connector, ground lift
Effects Loop Parallel type with return level control
Bass Control Shelving type, ±15 dB at 60 Hz
Mid Control ±15 dB at 650 Hz
Treble Control Shelving type, ±15 dB at 10 kHz
Brite Control ±15 dB at 9 kHz
Notch Filter >-18 dB sweepable from 30 to 700 Hz
High Pass Filter -12 dB/octave sweepable from 30 to 700 Hz
Reverb (Contra R and Coda R only)
Type
Digital with 8 presets and level control
Reverb Presets 2 Hall (Concert Hall, Arena), 3 Room (Club,
Chamber, Garage), 2 Plate (Plate, Vocal) and
1 Spring
Power Amp (all models)
Topology
Class D (PWM)
Switching Frequency 280 kHz
Output Power >200 W, >300 W with 4 Ω ext. cab.
New Yorker is 250W and 350W, respectively
External Speaker Output Neutrik Speakon type (pole 1), 4 Ω min.
Speaker System (all models)
Woofer
10 inch, downfiring
Midrange 5 inch, forward firing
Tweeter 1 inch forward firing with on/off switch
Crossover Passive, alignment corrected
Impedance 4 Ω
Power rating 300W
Available Accessories Padded gig bag with shoulder strap, deluxe gig
bag made by Mooradian, hard shell case,
“twist lock” to “twist lock” and “twist lock” to 1/4
inch speaker cables.
Specifications
8
Warranty Information
Serial Number ________________________________
Acoustic Image
7517 Precision Dr, Suite 102
Raleigh, North Carolina 27617
919-598-3113 (Phone)
919-957-3294 (Fax)
Web Site: www.acousticimg.com
Email: [email protected]
front edge of the cabinet. The peg should be stored in the clip when the amp
is being transported in order to avoid damage to the peg or nut. You may want
to use the lifter at all times in order to aim the high frequency output of the
speaker toward your ear so that you can better hear the amp.
Tweeter Switch
An on-off control for the tweeter is mounted in a recessed cup on top of the
cabinet just behind the rear panel. The tweeter is engaged when the switch
paddle is pointing toward the front of the cabinet. Try the unit with the tweeter
on and off to decide which sounds best to you.
Care
Acoustic Image combos and cabinets are made from lightweight but strong
materials. A little care will keep yours looking new for years to come. Use a
clean, dry cloth to clean the metal parts of the amplifier. The cabinet covering
can be brushed or vacuumed to keep it dirt and lint free.
Warranty and Repair
We stand behind our products with a full warranty of five years from the date
of purchase. Should a problem arise, please call us before returning your
amplifier or enclosure . Naturally, our warranty does not cover products that
have been damaged through misuse.