Acrosser AR-B6003 - Manual (Page 23)

3.3 PnP/PCI Setup
The option configures the PCI bus system. All PCI bus system on the
system use INT#, thus all installed PCI cards must be set to this value.
Note: Listed at the bottom of the menu are the control keys. If you need any
help with the item fields, you can
relevant information.
press the <F1> key, and it will display the
Choice Description Option
Reset Configuration
Data
Enabled
Disabled(Default)
elect Enabled to
when
nflict,
Normally, you leave this field Disabled. S
reset Extended System Configuration Data (ESCD)
you exit Setup. If you have installed a new add-on and the
system reconfiguration has caused such a serious co
then the operating system cannot boot .
Resources
Controlled By
Auto(ESCD)(Default)
Manual
capability means
ay choose specific resources by
ng into each of the submenus.
The Award Plug and Play BIOS has the capacity to
automatically configure all of the boot and Plug and Play
compatible devices. However, this
absolutely nothing unless you are using a Plug and Play
operating system such as Windows 95. If you set this field
to “manual,” then you m
goi
IRQ Res
hen resources are controlled manually, assign a type to
evice ources N/A each system interrupt, depending on the type of the d
that uses the interrupt
W
23