Acrosser AR-ES6003FL - Manual (Page 53)

5.3 PnP/PCI Setup
The option configures the PCI bus system. All PCI bus system on the
system use INT#, thus all installed PCI cards must be set to this value.
Note: Listed at the bottom of the m
help with the item fields, you can
ation
enu are the control keys. If you need any
press the <F1> key, and it will display the
relevant inform .
Option Choice Description
Enabled
ed to
d the
t,
Disabled(Default)
Normally, you leave this field Disabled. Select Enabl
reset Extended System Configuration Data (ESCD) when
you exit Setup. If you have installed a new add-on an
system reconfiguration has caused such a serious conflic
then the operating system cannot boot .
Reset Configuration
Data
Auto(ESCD)(Default)
Manual
ot and Plug and Play
s Windows 95. If you set this field
manual,” then you may choose specific resources by
ng into each of the submenus.
The Award Plug and Play BIOS has the capacity to
automatically configure all of the bo
compatible devices. However, this capability means
absolutely nothing unless you are using a Plug and Play
operating system such a
Resources
Controlled By
to “
goi
IRQ
e to
ending on the type of the device
that uses the interrupt
Resources N/A
When resources are controlled manually, assign a typ
each system interrupt, dep
53