Acrosser AIV-HM76V1FL - Manual (Page 6)

AIV-HM76V1FL Series User Manual
6 Acrosser Technology Co., Ltd.
Communication and I/O
Ethernet Chip • Intel 82574L PCIe LAN
Ethernet • 2 x PCIE*1 Intel GbE chip via RJ-45 connector
USB Port • 3 x External USB3.0 connectors
• 2 x Mini PCIe slot for 3.5G WiFi module
• 1 x for proprietary Bluetooth -> (1 x 5-pin 1.0mm WTB
Connector 180°)
• 1 x for proprietary GPS -> (1 x 5-pin 1.0mm WTB
Connector 180°)
Serial Port • COM1~3: Internal Pin Header (RS-232)
• COM4: Internal Pin Header (RS-422/485 Selected By
GPIO)
CANBUS • Use GPIO DB15 connection
1. Support both CAN 2.0A and 2.0B protocol
2. Programmable baud rate: from 5K bps Maximum 1M
bps or user-defined baud rate
3. Time stamp of CAN message
4. API library for user development
5. CAN bus device status query
GPIO • GPIO 4-in / 4-out, DB15 male
• Connector Input:
1. 4-input isolated channels
2. Max. voltage: 32V
3. Signal type:
A. Open/Ground switch input
B. Digital Logic
Logic High: 3V ~ 32V
Logic Low: 0V ~ 0.7V
• Maximum input frequency: 10KHz (duty = 50%)
• Output:
1. 4 channels
2. Output type: Open drain MOSFET driver
3. Output voltage range: 5V ~ 28V
4. Sink current: maximum 500mA each channel
5. Power on initial state: MOSFET off
6. Use clamped diode protection
7. Output default set: Low
SIM • SIM card slot
Power Output • Output power from COMBO connector
LED • Status indicator, 1 x 3 LED
• Green: PIC Status, Green: HDD, Yellow: Power
MiniPCIe Slot • MiniPCIe1 for 3.5G card (Reserve SIM interface)
• MiniPCIe2 for WiFi card