Acrosser AIV-HM76V1FL User Manual
Page 57
AIV-HM76V1FL Series User Manual
57
Syntax:
i32 setRemoteSwitch(u8 val)
Description:
The function sets the status of the Remote Switch.
Parameters:
This function takes an unsigned char as the parameter.
The value of this parameter can be ‘ENABLED’ (0x5A) or
‘DISABLED’(0xA5).
Return Value:
If this function works successfully, it returns 0, any other
value standards for error.
Syntax:
i32 getBattValt(float *vol)
Description:
This function gets the battery voltage ant put it in the
memory which is pointed at by the pointer ‘vol’.
Parameters:
This function takes a pointer to a ‘float’ variable as the
parameter. The reading of the battery voltage is put at the
memory which is pointed at by the parameter ‘vol’.
Return Value:
If this function works successfully, it returns 0, any other
value standards for error.
Syntax:
i32 getBattMonitor(u8 *val)
Description:
The function gets the status of the Battery Monitor.
Parameters:
This function takes a pointer to an unsigned char variable
as the parameter. After calling this function, the status
of the Battery Monitor will be put at the memory which is
pointed by the parameter ‘val’. If the Battery Monitor is
enabled, ‘*val’ is 0x5A. If the Battery Monitor is disabled,
the ‘*val’ is 0xA5. Users can use the macros ‘ENABLED’
(0x5A) and ‘DISABLED’(0xA5) to test the status value
‘*val’.
Return Value:
If this function works successfully, it returns 0, any other
value standards for error.
Syntax:
i32 setBattMonitor(u8 val)
Description:
The function sets the status of the Battery Monitor.
Parameters:
This function takes an unsigned char as the parameter.
The value of this parameter can be ‘ENABLED’ (0x5A) or
‘DISABLED’(0xA5).
Return Value:
If this function works successfully, it returns 0, any other
value standards for error.