Acrosser AR-B1651 User Manual
Acrosser Computer Accessories
Advertising
Table of contents
Document Outline
- PREFACE
- 1. INTRODUCTION
- 2. SETTING UP SYSTEM
- 2.1 AR-B1651 OVERVIEW
- 2.2 SYSTEM SETTINGS
- 2.2.1 Keyboard & Mouse Connector (KM1)
- 2.2.2 SDRAM SOCKET 144 PIN (DIMM1)
- 2.2.3 Hard Disk (IDE) Connector (IDE1)
- 2.2.4 FDD Port Connector (FDD1)
- 2.2.5 Parallel Port Connector (LPT1)
- 2.2.6 CRT Connector (CRT1)
- 2.2.7 USB Connector (USB1)
- 2.2.8 LVDS Header (LVDS1)
- 2.2.9 VOLTAGE SELECT (JP2)
- 2.2.10 PANEL BACKLIGHT CONNECTOR(JP5)
- 2.2.11 Serial Port (COM1, COM2)
- A. COM1
- B. COM2
-
- 2.2.12 RS-485 Terminator Select (JP1)
- 2.2.13 RS-485 Header (JP3)
- 2.2.14 Touch Screen Connector (TS2)
- 2.2.15 26-Pin Audio Connector (AUDIO1)
- 2.2.16 CPU Fan Power Connector (JFAN1)
- 2.2.17 External Buzzer (U6)
- 2.2.18 Infrared Connector (IR1)
- 2.2.19 LED (J1)
- 2.2.20 Ethernet RJ-45 Connector (LAN1)
- 2.2.21 Reset Button (RST1)
- 2.2.22 Power Connector (PWR2)
- 2.2.23 PC/104 Connector (PC1)
-
- 3. CRT/LCD FLAT PANEL DISPLAY
- 4. WATCHDOG TIMER
- 5. BIOS CONSOLE
- 5.1 BIOS SETUP OVERVIEW
- 5.2 ADVANCED
- Quick Power On Self Test [Enabled]
- Full Screen Logo Show [Disable]
- PNP OS Installed [NO]
- Swap Floppy Drive [Disabled]
- USB Keybord Support [Disable]
- INIT Display First [PCI SLOT]
- Frame Buffer Size [8M]
- ACPI Function [Disable]
- Onboard Serial Port 1 [AUTO]
- Onboard Serial Port 2 [Auto]
- UART 2 MODE [Standard]
- Select an operating mode for the second serial port:
- Onboard Parallel Port [378H/IRQ7]
- Onboard Parallel Mode [Normal]
- ECP Mode use DMA [3]
- Parallel port EPP Type [EPP1.9]
- Onboard FDC controller [Enables]
- OnChip USB [Enables]
- 5.4PnP/PCI
- Reset Configuration Data [Disable]
- Resources Controlled By [Auto (ESCD)]
- 5.5 PC HEALTH
- 5.6 BOOT
- 5.7 BIOS EXIT
- Save & Exit Setup
- Load Optimized Defaults
- APPENDIX A. I/O & MEMORY MAP
- APPENDIX B. INTERRUPT REQUEST (IRQ)