Acrosser AR-B9622 - Manual (Page 35)

AR-B9622 User’s Guide
5. INSTALLATION
This chapter describes the procedure of the installation. The following topics are covered:
Overview
Utility Diskette
Watchdog Timer
5.1 OVERVIEW
This chapter provides information for you to set up a working system based on the AR-B9622 CPU board.
Carefully read the details of the CPU board’s hardware descriptions before installation, especially the jumper
settings, switch settings and cable connections.
Follow the steps listed below for proper installation:
Step 1 : Read the CPU board’s hardware description in this manual.
Step 2 : Set jumpers.
Step 3 : Make sure that the power supply connected to your passive CPU board is turned off.
Step 4 : Connect all necessary cables. Make sure that the FDC, HDC, serial and parallel cables are
connected to pin 1 of the related connector.
Step 5 : Connect the hard disk/floppy disk flat cables from the CPU board to the drives. Connect a power
source to each drive.
Step 6 : Plug the keyboard into the keyboard connector.
Step 7 : Turn on the power.
Step 8: Configure your system with the BIOS Setup program then re-boot your system.
Step 9: If the CPU board does not work, turn off the power and read the hardware description carefully
again.
Step 10: If the CPU board still does not perform properly, return the board to your dealer for immediate
service.
5.2 UTILITY DISKETTE
AR-B9622 provides two VGA driver diskettes, supporting WIN31 & DOS applications. If your operating system is
the other operating system, please contact Acrosser that will provide the technical supporting for the VGA
resolution.
There are two diskettes: disk 1 is for WIN31 & MS-DOS VGA resolution, disk 2 is for the network utility and manual.
Every diskette is attached with the README.* file. Please refer to the file of README for any troubleshooting
before installing the driver.
5-1