5 pnp/pci configuration, 6 load default setting, 1 load bios defaults – Acrosser AR-B1565 User Manual
Page 38
AR-B1565/1565A User!s Guide
37
5.5 PNP/PCI CONFIGURATION
PNP/PCI CONFIGURATION
PNP OS Installed
This item is to choose whether or not installing the PNP (Plug & Play) operation system.
Resources Controlled By
The available choices are <Auto>&<Manual>. To choose <Auto>the resources will be under the control of
system automatically. If <Manual> is chosen, the following items will be listed.
<IRQ (3,4,5,7,9,10,11,12,14,15)> Setting these items one by one will clear up the conflict between NON-PNP
ISA extension cards and PNP system.
<DMA (0,1,3,5,6,7)> these items are used for the PNP ISA (PCI) cards or NON-PNP old ISA cards which use
DMA channel to enable them work normally.
Reset Configuration Data
This item is used to <enable> the function of Reset Configuration Data or not.
PCI IRQ Actifed By
This item is to determine the active mode.
5.6 LOAD DEFAULT SETTING
This section permits the user to select a group of settings for all BIOS Setup options. Not only can you use these
items to quickly set system configuration parameters, you can choose a group of settings that have a better chance
of working when the system is having configuration related problems.
5.6.1 Load BIOS Defaults
User can load the optimal default settings for the BIOS. The <LOAD BIOS DEFAULTS> uses best-case values
that should optimize system performance. If CMOS RAM is corrupted, the optimal settings are loaded
automatically.
Load high performance settings (Y/N)?