Acrosser AR-B1640 - Manual (Page 25)

AR-B1640 User’s Guide
25
5.6 PCI/PLUG AND PLAY
This section is used to configure PCI / Plug and Play features. The <PCI & PNP Setup> option configures the PCI
bus slots.
PCI / Plug And Play
Plug and Play Aware O/S
Set this option to Yes if the operating system installed in the computer is Plug and Play-aware. The BIOS only
detects and enables PnP ISA adapter cards that are required for system boot. The Windows 95 operating system
detects and enables all other PnP-aware adapter cards. Windows 95 is PnP-aware. Set this option <No> if the
operating system (such as DOS, OS/2, Windows 3.x) does not use PnP. You must set this option correctly or
PnP-aware adapter cards installed in your computer will not be configured properly.
Clear NVRAM
This sets the operating mode of the boot block area of the BIOS FLASH ROM to allow programming in the Yes
setting.
PCI Latency Timer (PCI Clocks)
This option sets latency of all PCI devices on the PCI bus. The settings are in units equal to PCI clocks.
Primary Graphic Adapter
This option is set to use PCI bus or AGP. The AGP mode will get system a faster processing speed.
DMA & IRQ
These options specify the bus that the named IRQs/DMAs lines are used on. These options allow you to specify
IRQs/DMAs for use by legacy ISA adapter cards. These options determine if the BIOS should remove an IRQ/DMA
from the pool of availability of IRQs/DMAs passed to the BIOS configurable devices. If more IRQs/DMAs must be
removed from the pool, the end user can use these PCI/PnP Setup options to remove the IRQ/DMA by assigning
the option to the ISA/EISA setting. The onboard I/O is configurable with BIOS.