Dolby Laboratories DP572 User Manual
Page 46
Dolby E Multichannel Distribution System User Manual
DP571 Dolby E Encoder
3-14
Reversion Preset
Figure 3-8 Reversion Preset menu
Reversion Preset specifies a Program Config to use in case an external metadata source is
interrupted. See Metadata Revert on page 9 for more information on this feature.
Channel Mode
1/0 Mono: Single front channel, no surround channels. For a two-channel system, the
signal is reproduced equally from both channels attenuated 3 dB. For a
5.1-channel system, the signal is reproduced from the center channel
(L, R, LS, RS channels are not used).
2/0 Stereo: Left and right channels, no center or surround channels. For a two-channel
system, the signal is reproduced equally from the L, R channels. For a 5.1-
channel system, the signal can either be reproduced from only the L, R
channels or, optionally, from L, C, R, S (see Dolby Srnd Mode).
3/0:
Left, center, and right channels, no surround channels. For a two-channel
system, the L, R signal is reproduced equally from the L, R channels; the
center channel is attenuated 3 dB and sent to the L, R channels. For a 5.1-
channel system, the signal is reproduced by the L, C, R channels.
2/1:
Left, right, and surround channels. For a two-channel system, the L, R signal
is reproduced equally from the L, R channels; the surround channel is
attenuated 3 dB and sent to the L, R channels. For a 5.1-channel system, the
signal is reproduced by the L, R, S channels. This is an extremely un-
common format.
3/1:
Left, center, right, and surround channels. For a two-channel system, the
L, R signal is reproduced equally from the L, R channels; the center and
surround channels are attenuated 3 dB and sent to the L, R channels. For
a 5.1-channel system, the signal is reproduced by the L, C, R, S channels.
2/2:
Left, right, left surround, and right surround channels. For a two-channel
system, the L, R signal is reproduced equally from L, R channels; the Ls, Rs
channels are attenuated 3 dB and sent to the L, R channels, respectively.
For a 5.1-channel system, the signal is reproduced by the L, R, Ls, Rs
channels. This format is sometimes called quad.
3/2:
Left, center, right, left surround, and right surround channels. For a two-
channel system, the L, R signal is reproduced equally from the L, R
channels. The center channel is attenuated 3 dB and sent to the L, R channels.
The Ls, Rs channels are attenuated 3 dB and sent to the L, R channels,
respectively. For a 5.1-channel system, the signal is reproduced by the
L, C, R, Ls, Rs channels.
Metadata Params
Program 1-N
Metadata Params
Reversion Preset
Reversion Preset
Program Config
See the Program Config section for possible settings.
Enter
Esc
Enter
Esc