ADLINK PCI-7200 - Manual (Page 46)

34 Operation Theory
4.2 Timer Pacer Mode
The digital I/O access control is clocked by timer pacer, which is
generated by an interval programming timer/counter chip (8254).
There are three timers on the 8254. Timer 0 is used to generate
timer pacer for digital input and timer 1 is used for digital output.
The configuration is illustrated as below.
The operation sequences are:
1. Define the frequency (timer pacer rate)
2. The digital input data are saved in FIFO after a timer
pacer pulse is generated. The sampling is controlled by
timer pacer.
3. The data saved in FIFO will be transferred to main mem-
ory of the computer system directly and automatically.
This is controlled by bus mastering DMA control, this
function is supported by PCI controller chip.
The operation flow is show as following:
Timer 0
Timer 1
Timer 2
CLK0
GATE0 OUT0
CLK1
GATE1
CLK2
GATE2
OUT1
OUT2
8254 Timer/Counter
Digital Input Timer Pacer
Digital Output Timer Pacer
4MHz Clock
“H”
“H”
“H”