ADLINK AMP-208C - Manual (Page 26)

12 Getting Start with The Installation
2.3 Hardware Installation
2.3.1 Hardware Configuration
AMP-204C/208C employs PCI Rev. 2.2 bus. System BIOS can
auto configure memory and IRQ channel.
Exclusive terminal board DIN-825-GP4 provides isolation circuit
and indicator lights for easy connections to varieties of servo drive
and stepper drive.
2.3.2 Installation Procedures
1. Please read this manual carefully and set up signal I/O in
proper mode.
2. Turn off power of your computer and all relevant terminal
boards, insert your AMP-204C/208C to any 32-bit PCI
slot in your computer. (The slot is usually in white color.)
(Please make sure you have proper ESD (Electrostatic
discharge) protection.)
3. Connect AMP-204C/208C and DIN-825-GP4 with SCSI
100p cable
4. Set up motion control relevant limit switch on
DIN-825-GP4 board, servo signal and general purpose
digital signal wiring
5. Set up servo or stepper drive connection
6. Turn on system power including computer power,
terminal board relevant powers, and 24Vdc power
7. Verify all I/O signal and servo operation correctness with
MotionCreatorPro 2
CAUTION
Please ground the shielding end of the power terminal to the
earth to reduce risk of electric shock and ensure product
operation of your electric appliances.
CAUTION
Please disconnect the motor drive from its load before using
the card for the first time to protect your safety. Do not connect
the motor drive to any mechanical devices before the
completion of the installation and fine tuning of the control
system. Connect the system only after the board is adjusted
and the drive parameters can control the motor. Serious
damage may be resulted in otherwise.