ADLINK aTCA-N700 - Manual (Page 23)

Switch Manager API Programming Guide
23
UINT32 rx_pkt_rate;
UINT32 tx_byte_num;
UINT32 tx_byte_rate;
UINT32 tx_pkt_num;
UINT32 tx_pkt_rate;
}adlink_portstat_t;
Define the entry format of the port statistic table.
adlink_set_port_status_cmd_t
typedef struct adlink_set_port_status_cmd {
UINT32 port; /*port ID*/
UINT32 flag; /*PORT_ATTR_xxx in port_attribute_t*/
int status; /*ENABLE/DISABLE*/
int autoneg_mode; /*ENABLE/DISABLE*/
int duplex_mode; /*PORT_DUPLEX_xxx in port_duplex_t*/
int speed_mode; /*PORT_SPEED_xxx in port_speed_t*/
int pvid; /*default 802.1Q vid for untagged packets*/
int cos; /*default 802.1Q cos for untagged packets*/
int mtu; /*max data transmission unit*/
} adlink_set_port_status_cmd_t;
Define the format of parameters used to set port attributes.
adl_nic_config_set_cmd_t
typedef struct adl_nic_config_set_cmd {
char if_name[TAPNAMSIZ];
UINT32 config_mask; //nic_config_mask_t
UINT32 ip;
UINT32 netmask;
UINT32 status; //0 down, 1 up
}adl_nic_config_set_cmd_t;
Define the format of parameters used to set NIC configuration.
adl_nic_config_info_t
typedef struct adl_nic_config_info
{
UINT32 ip;