1 clear cmos jumper, 2 dc 5v and 3.3v connectors for gps module, Clear cmos jumper – ADLINK MXE-5400 User Manual
Page 35: Dc 5v and 3.3v connectors for gps module, Table 1-13, Clear cmos jumper pin assignment, Figure 1-18, Clear cmos jumper pin settings, Preliminary
Advertising
PRELIMINARY
Introduction
23
MXE-5400
1.8.1
Clear CMOS Jumper
Under conditions in which the MXE-5400 fails to boot, clearing the
BIOS content stored in CMOS and restoring the default settings
may be effective. To clear CMOS, short Pin#1 and Pin#2 of CN3
and remove the jumper, after which the CMOS will be restored to
factory default settings.
Figure 1-18: Clear CMOS Jumper Pin Settings
Table 1-13: Clear CMOS Jumper Pin Assignment
1.8.2
DC 5V and 3.3V Connectors for GPS Module
The two power connectors, for GPS module use, carry a maxi-
mum current rating of 1A each.
Normal
Clear
Pin
Description
1
RTCRST#
2
Gnd
CN3 CN4
1
2
1
2
CN3 CN4
1
2
1
2
Advertising