ADLINK MilSystem 800 - Manual (Page 13)

MilSystem Setup
MilSystem User’s Guide 9
Table 6. I/O Panel Connectors (Refer to Figure 3 for connector locations.)
MC (Military Connector) Pin Definitions
The following three tables break down the signals of the three military I/O connectors (MC) on the
MilSystem. Each table lists the MC pin number, the mating breakout cable connector, the breakout cable
connector pin number, and the signal name and description of each pin on the military connector.
Control/Connector Description
MC-1 This military connector provides signals for VGA, Ethernet, PS2 Keyboard,
Stereo Audio Out, Stereo Line In, Mic In, ACPI Power In, Reset In, Power On
LED, HDD Activity LED, SATA, USB 2.0.
MC-2 This military connector provides signals for USB 2.0, Ethernet, and RS232/485/
422 COM Ports.
MC-3 This military connector provides signals for Parallel and LVDS.
Power This Military Power connector accepts DC voltages from an external source. This
connector is available in two versions depending on the MilSystem model:
• The MILxxx models provide +12VDC to +25VDC power connectors.
• The MILxxxW models provide +14VDC to +32VDC power connectors.
NOTE This connector is manufactured by Amphenol,
P/N PT06E-8-4S(023).
NOTE To connect a Hard Disk Drive (HDD) or CD-ROM to the MilSystem, use
one of the USB or SATA ports to connect the device.
Table 7. MC-1 Connector Pin Signals
MC
Pin # Breakout Cable
Connector Breakout
Cable Pin # Signal Signal Description
1 VGA 1 RED Red Analog Output
2 VGA 6 GND1 Ground
3 VGA 2 GREEN Green Analog Output
4 VGA 7 GND2 Ground
5 VGA 3 BLUE Blue Analog Output
6 VGA 8 GND3 Ground
7 VGA 13 HSYNC Horizontal Sync
8 VGA 10 GND4 Ground
9 VGA 14 VSYNC Vertical Sync
10 VGA 9 PWR Power
11* VGA 12 SDA Display Data Channel
(DDC) - Data
12* VGA 15 SCL Display Data Channel
(DDC) - Clock
NC 4 Not connected
NC 5 Not connected
13 Ethernet 1 MDI0_P Ethernet0 Positive
14 Ethernet 2 MDI0_N Ethernet0 Negative