Advanced Control Technologies Specs Instructions ZDW232 (RF 230 VAC, 500W, IncandescentWall Dimmer,Two Wire, White) - Manual

ZDW232 Instructions, Release 1.1
P/D 100407
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0747-01
1
Radio Frequency Controlled, 230 VAC, Single European Wall
Mounted, 500W, 2-Wire Dimmer Receiver, Release 1.1
ZDW232
ZDW232 WALL MOUNTED DIMMER
The ZDW232 Wall Mounted Dimmer is a component of the HomePro lighting control system. Wire the Wall Mounted
Dimmer in place of the standard wall switch according to the diagram above and configure from the Wireless
Controller to operate loads. Inclusion of the ZDW232 Wall Mounted Dimmer on the ZTH200 Wireless Controller
menu allows remote ON/OFF control and dimming of light connected.
There are no field repairable assemblies on this unit. If service is needed, the unit must be returned where purchased.
INSTALLATION
DANGER! Shock Hazard. Read and understand these instructions before installing. It is recommended that
a qualified electrician perform this installation.
To reduce the risk of overheating and possible damage to other equipment, do not install to control a
receptacle, a motor operated appliance, a fluorescent lighting fixture, or a transformer-supplied appliance, but
only permanently installed incandescent lamp fixtures. Make sure the lamp(s) to be controlled directly from the
dimmer receiver total no more than 500 watts. Retain instructions for future use.
1. Remove the paddle. Using small screw driver, push out the paddle through holes in back side of mounting
plate. The paddle can also be pried out from the face, from the top or the bottom of the paddle.
2. Remove the four screws through the retaining ring holding the Trim ring to the mounting plate. This will
allow removal of Trim ring. When removing the Trim ring make sure not to bend or disrupt the shape of
the antenna wire.
3. Wire the product according to the diagram.
4. Install the product in the wall box.
5. Re-install the Trim ring and the retaining ring with the four screws. Position of this ring is important. The
stamped word “Bottom” on the Metal and retaining ring will be aligned with each other. Again do not
disrupt the integrity of the antenna wire.
6. Return the Paddle to the face of the product. Simply press into place. Make sure the LED window is also
toward the stamped word “Bottom” on the retaining ring.
HomePro
RF Home Automation
ZDW232
ZDW232 Connections:
1: Line Voltage Input
1: Line Voltage Input (alternate)
X: (not used)
X: (not used)
2: Load
2: Load (alternate)
Note: This module must be “Included in the
Network” only where it will be permanently
installed. The proper operation of this node in the
mesh network is dependent on it knowing its
location with respect to other nodes. You cannot
“test bench” configure this module.
(see alternate wiring schemes - Page 6)