Advanced Control Technologies Specs Instructions ZRR150W (RF Receptacle, 120 VAC, 15A,One Outlet Controlled, White Enclosure) - Manual

ZRR150 Instructions, Rel. 1.2
103107
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0738-01
1
Radio Frequency Controlled, 120 VAC,
15A, Duplex Receptacle, Rel. 1.2
ZRR150
HomePro
RF Home Automation
ZRR150 DUPLEX RECEPTACLE
The ZRR150 Duplex Receptacle is a component of the HomePro lighting control system. Wire the Duplex Receptacle
in place of the standard receptacle according to the diagram above and program from the Wireless Controller to operate
loads. Inclusion of this Receptacle on the ZTH100 Wireless Controller menu allows remote ON/OFF control of loads
connected to the controlled outlet. The other outlet remains powered all the time.
This ZRR150 Duplex Receptacle is designed to work with other Z-Wave enabled devices. Z-Wave nodes of other types
can be included in the system and will also act as repeaters if they support this function of repeating the signal received
to other modules in the system.
This product supports 40Kbps data transmission. This product can also be used for networking support in
systems that stream metadata. An example might include transmission of information from audio devices such as song
title, artist, and album information to various displays around the home.
As part of a Z-Wave network, the ZRR150 will also act as a wireless repeater to insure that commands intended for
another device in the network are received. This is useful when the device would otherwise be out of the radio range
of the wireless controller.
There are no field repairable assemblies on this unit. It is covered by a one year limited warranty. If service is needed,
the unit must be returned where purchased.
DANGER! SHOCK HAZARD. Read and understand these instructions before installing. This device is intended for
installation in accordance with the National Electric code and local regulations in the United States, or the Canadian
Electrical Code and local regulations in Canada. It is recommended that a qualified electrician perform this installation.
Make sure the load controlled does not exceed 1800 watts. For indoor use only. Retain instructions for future use.
INSTALLATION
Wire this Receptacle in place of a current receptacle according to the diagram above. See the ZTH100 Wireless
Controller operating instructions to add this module under the command of the Wireless Controller.
INCLUDING ZRR150 TO THE NETWORK
STEP 1.. Prepare the Controller to include a unit to the network by adding it to a group (method of adding a node
to the network). Refer to controller instructions.
Note: This module must be “Included
in the Network” only where it will be
permanently installed. You cannot
“test bench” configure this module,
then install. The proper operation of
this node in the mesh network is de-
pendent on it knowing its location with
respect to other nodes.
Controlled Outlet
Always Powered Outlet
NOTE: THIS RECEPTACLE HAS THE “SENSE FEATURE:
The lower outlet will “sense” if the load it controls is switched
on. The outlet responds by turning ON. The top outlet is
always powered.