Altech UEC DT 3900RF - Manual (Page 14)

14
6. BASIC SET UP- RF
Uses the RF connector on the back of the receiver to provide a complete
digital video and audio connection in one neat cable. A RF cable of length
to suit your purpose is required. All video outputs are active.
6.1. Prepare your equipment
Ensure the power leads to both display and receiver are unplugged whilst
making your AV connections. Your TV must have a RF input.
6.2. Connect the antenna…
to the “ANTENNA IN” socket on the rear of your receiver.
6.3 Tuning TV
Select a channel on your TV set and scan in the UHF band the output from
DT3900RF
6.4. Mains Power
Turn on your set top at the mains power & you are ready to scan.
Video and Audio share the one RF cable
REBOOT THE RECEIVER
Resetting to factory default can be useful if you have change some settings
and lost some functions. Resetting takes the receiver back to its original
configuration and you will lose all personalized functions (favorites,
parental lock, etc…). To avoid resetting the receiver accidentally, you are
required to enter a PIN CODE to authorize reset as follows:
• Menu / Settings / Factory Reset
• Press the red button to confirm.
• Enter your PIN CODE (4 digits – factory code is 0000).
• Wait a few seconds