Alwarerc Eagle Pro V4 Camera 3-Axis 360D Panning Gimbal - Manual (Page 13)

Install 4pcs Flange Bearings and 8pcs Nylon
washers again.(Part No.: 4, 13)
Insert the Outer Frame and secure it with
M2X6mm Hex Cap Screws and with 2pcs
Washers.(Part No.: 7, 9)
Hole and compress two Alu Roll Bearing shafts
with hand and tighten the shafts using M2x6 Hex
Cap Screws .(This step will affect the smoothness
and tolerance of the Roll Axis movement.)
Install second servo like the picture. Make sure
the installation direction is correct.(With Parts No.:
3, 6, 14)
Install third servo with M2x8mm Hex Cap Screws
and M2 Nuts.Make sure the direction is correct.
(Part No.: 5, 8)
That is the end of Part 2.
13