Amaircare 7500 - Manual (Page 4)

FILTER REPLACEMENT INSTRUCTIONS
The AMERICAIR HEPA Air Filtration System is designed to run continuously. To ensure
optimal performance, please carefully follow the Product Information and Owner’s
Manual Instructions.
FILTER REPLACEMENT INSTRUCTIONS:
1. Read these instructions completely.
2. Turn the unit ‘off’ and unplug it from the power supply outlet.
3. Remove the safety screw from the front of the unit (located at the top)
4. Lift the front door of the unit up and pull it out to remove it from the unit. This will
allow access to the filter compartment.
5. Remove the HEPA cartridge(s) from the unit by turning it counter clockwise and lift out.
NOTE: The foam pre-filter and the HEPA filter will contain contaminants. Remove
them slowly from the unit in order to avoid dusting.
6. To remove the first-stage filter simply lift the foam from the bottom, pull it off.
Wash if desired, or replace with new
7. To replace the first stage filter pull the foam filter over the HEPA cartridge and
gently pull it down until it completely covers the HEPA filter (white portion).
8. To replace the 3rd stage V.O.C. filter, fold the ends of the old Inner Blanket in, and
remove it from the unit. Insert the new Inner Blanket inside the HEPA Cartridge with
the edges overlapping. Once it is in position gently spread the Inner Blanket against
the HEPA filter until the two ends of the blanket meet.
9. Replace the HEPA cartridge, complete with the new pre-filter and inner blanket
(if changed) into the unit. Turn HEPA filter clockwise until it locks into position.
10. After the filter(s) has been replaced, replace the front door, and replace the safety
screw.
11. Plug in the unit and turn it on.
OPERATING INSTRUCTIONS
With proper care and maintenance, you will enjoy many years of service and dra-
matically improve the quality of your indoor air. The AMAIRCARE
® HEPA Air Filtration
System is deigned to operate continuously.
INSTRUCTIONS
1. Plug the unit into a grounded outlet 120 Volt, 60 Hz (or 230 Volt, 50/60 Hz
Depending on the area in which the unit was sold).
2. Turn the unit on by rotating the control dial clockwise until you hear or feel it
click.
3. The unit will come on in the “HIGH” position. To Reduce the air flow, continue to
rotate the control dial clockwise.
4. To turn the unit off, rotate the dial counter-clockwise past the “HIGH” position
until you hear or feel it click.
CAUTION!
1. Make sure that the line cord is not in the path of people walking or where any-
thing can be rolled over it.
2. Locate the unit such that there is no possibility of moisture dripping on it.
Moisture could leak into the unit and damage the filter or electrical components.
3. The Air Filtration System discharges clean air through the outflow collars on the
side.
NOTE: You may notice a slight “new” smell from the Air Filtration System when you
first turn it on. This is normal and harmless and it will dissipate within a few days.
HEPA Filter Replacement
As the HEPA filter captures particulates, it will darken over time.
Replace the HEPA filter when it darkens to example D.
A. New B. Used C. Used D. Replace