American Energy Systems MF3514 Fuel Stirrer Drive Shaft - Manual

F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3514 Fuel Stirrer Drive
Shaft.doc
MF3514 Fuel Stirrer Drive Shaft
All Magnum Countryside units and 7500 (from 2001 to present)
• Remove from packaging.
• Turn off power on control panel and
unplug from the power supply.
• Open right side panel.
• Remove firepot assemble.
• Remove the drive sprocket.
• Slide the drive shaft out.
• Replace fuel stirrer drive shaft with new
shaft that has been lightly brushed with
Hi-temp grease then slide the collar onto
the shaft.
• Slide the shaft and collar into the hole.
• Slide on the auger motor by aligning the flat shaft on the auger to the Allen screw on
shaft collar and then tighten the set screw on the collar.
• The fuel stirrer /stirrer drive shaft should have about 1/8” lateral movement when fully
assembled. The stop tab can be adjusted to provide
1/16” movement if necessary. This is done by
bending the tab in or out 1/32” maximum to assist
with fit and function. IF this does not work,
remove and re-install FIREPOT/FUEL STIRRER.
• Tighten the set screw on sprocket.
• Close side panel.
• Restart unit.